b1038 timeout problems.

[Joker]

After upgrading to 1038 from 1031 ive experienced that i get the timeut error every time. Ive went back using my flashfxp.exe.bak in the backup dir and the problem dissapered.
Then used the 1038b of flashfxp.exe and the problem occured again.

This only happens when i dl to my harddrive, not when i fxp.
So it definetly has to do with it.

[18:52:57] [R] 227 Entering Passive Mode (xxx,xxx,xxx,xxx,17,205)
[18:52:57] [R] PORT zzzz,zzz,zzz,zzz,12,214
[18:52:57] [R] 200 PORT command successful.
[18:52:57] [R] RETR xxxx.rar
[18:54:27] [R] 421 Timeout (90 seconds): closing control connection.
[18:54:27] [R] Transfer Failed!
[18:54:27] [R] Connection lost: xxxxxxxxxx
[18:54:29] [R] Attempting to Reconnect.
[18:54:30] [R] Connecting to xxxxxxxxxx

Then it transfers 2 files good, and then it doesnt even start to dl the third one just reaches to the RETR command and times out.

Running on winxp pro sp2, zone alarm as firewall (fully configurated and no logs bout blocked connections), kasperskys antivirus 5,0
And i have a cable connection, no router or anything.

As i said this doesnt occur with the build 1031.
And this happens on 2 sites that ive tried on.

[Hetfield]

Maybe you need to enable "send noops during transfer"?

[Joker]

i havent touched any settings at all.
But it seems like b1038 changed my settings and disabled noop (among other settings when i looked now).
Because ive always had send noop during transfer as checked.

Anyways the same test was made on b1031 with the send noops disabled also and no timeout problems there with that enabled or not.

Ok. checked that setting on b1038 and it works good now.

[bigstar]

Both builds 1031 and 1038 read the exact same values for these settings. This value shouldn't have changed itself as no code exists to do so. I simply can't explain this behavior.

The only value we changed in between 1031 and 1038 was the upload packet size, If you were using the default value of 4k it is updated to 8k. No other values should be changed.

[LordOfLA]

I have this error as pasted by Joker as well.

My question is why does FlashFXP issue PASV adn then follow that with PORT???

if we are performing a passive mode transfer port inst needed.

the port command results in a b0rked trasfer as you can see from jokers paste:

[18:52:57] [R] 227 Entering Passive Mode (xxx,xxx,xxx,xxx,17,205)
[18:52:57] [R] PORT zzzz,zzz,zzz,zzz,12,214
[18:52:57] [R] 200 PORT command successful.

If you stop the PORT command after PASV the timeout will go away.

HTH

[bigstar]

This problem should be solved in build 1039, Please let me know if it's not.

[LordOfLA]

yeah it is thanks