FlashFXP size & Position
 

WHen I fire up my FlashFXP, the size & position are restored to (apparently) the previous size. The main problem, is that the restore queue and the main window come up at about 200 pixels wide and 100 pixels high.

Is there a place to reset this? I tried the old windows trick, Shift while closing but the Pos & size do not reset, next time I open it, they are back to 200 px wide.

Any ideas?

Cary

oops, just read the May 29 (?) Post

Flash FXP 2.1 build 923
Windows XP Pro SP1
Netgear Router
NAV 8 Corp
Roadrunner Cable

if the new window size isn't being properly saved on exiting FlashFXP i'd suspect that maybe your flashfxp.ini file is marked as read-only.

If that still doesn't solve your problem you can edit the flashfxp.ini file directly remove the entire [window] section. this will reset all the window positions to default.

I tried that, I complete removed the variables under Window and Queue. When I fired it up, it looked exactly the same & the ini file was back to this:

[Window]

Left=248
Top=155
Width=312
Height=174
State=0
qTop=0
Queue=1
Status=1
TS=0.5
BS=0.5
CS=0.75
LTS=0
RTS=0
TVP=156

[QueueWindow]

Left=0
Top=0
Width=312
Height=213
State=0


PS: Flash was NOT running when I edited the ini file

I also tried width=900 and height=700 and it reverted back to those numbers once again.

What video resolution do you use?
Do you use a multi-monitor setup?

Yes, supposed I should have mentioned I use 2 monitors on an ATI Radeon 9600 the primary display is 1600x1200, the secondary is 1280x1024.

Thank you