BobbyBonilla
11-09-2003, 10:42 AM
Hello everyone :)
When I'm trying to nuke a directory I am always getting the following message in return:
site nuke /divx/Some.Releasename/ 1 no.reason
200--[Nuke]----------------------------------------------------------
200- Could not find dir to nuke
200------------------------------------------------------------[ioA]-
200 Command successful.
This is what ioa.debug says:
COMMANDLINE - nuke /divx/Some.Releasename/ 1 no.reason
NUKE nuke - /divx/Some.Releasename/
NUKE multi - 1
NUKE reason - no.reason
NUKE oldpath - f:\sections\divx\Some.Releasename\/divx/Some.Releasename/
NUKE newpath - f:\sections\divx\Some.Releasename\[Nuked]-/divx/Some.Releasename/
INFO - Check directories
Well, I ****ed up some important setting but I can't figure out which.
Thanx a lot in advance, Bobby.
When I'm trying to nuke a directory I am always getting the following message in return:
site nuke /divx/Some.Releasename/ 1 no.reason
200--[Nuke]----------------------------------------------------------
200- Could not find dir to nuke
200------------------------------------------------------------[ioA]-
200 Command successful.
This is what ioa.debug says:
COMMANDLINE - nuke /divx/Some.Releasename/ 1 no.reason
NUKE nuke - /divx/Some.Releasename/
NUKE multi - 1
NUKE reason - no.reason
NUKE oldpath - f:\sections\divx\Some.Releasename\/divx/Some.Releasename/
NUKE newpath - f:\sections\divx\Some.Releasename\[Nuked]-/divx/Some.Releasename/
INFO - Check directories
Well, I ****ed up some important setting but I can't figure out which.
Thanx a lot in advance, Bobby.