FlashFXP Forums - View Single Post

bigstar · 05-31-2002, 03:51 AM

Which model linksys router do you have? I am curious because I have one too and it doesn't disconnect me after every transfer.

The correct procedure is as followed.

Bind to IP is intended for non-passive mode transfers (active mode). In order for this to work correctly you will need to set your machine in DMZ mode or configure port forward a range (i.e. 9000 to 9005) of ports on the router.

If you setup port forwarding on a range of ports then you'll need to match this range (i.e. 9000 to 9005) in FlashFXP.

It is ideal to limit this range to 5 ports per instance of FlashFXP, so if you often run two copies of FlashFXP at once you would use 9000 to 9010.

05-31-2002, 03:51 AM
bigstar FlashFXP Developer Join Date: Oct 2001 Posts: 8,012	Which model linksys router do you have? I am curious because I have one too and it doesn't disconnect me after every transfer. The correct procedure is as followed. Bind to IP is intended for non-passive mode transfers (active mode). In order for this to work correctly you will need to set your machine in DMZ mode or configure port forward a range (i.e. 9000 to 9005) of ports on the router. If you setup port forwarding on a range of ports then you'll need to match this range (i.e. 9000 to 9005) in FlashFXP. It is ideal to limit this range to 5 ports per instance of FlashFXP, so if you often run two copies of FlashFXP at once you would use 9000 to 9010.