View Single Post
Old 02-29-2004, 12:01 PM  
Junior Member
Join Date: Feb 2004
Posts: 2

Originally posted by bigstar
I'm not very familiar with how this is done, but if your network is configured properly it should do this automatically.

The network interface is selected based on your network routing table.
How do you set this up, my knowledge of networking is low.

i have one nic that goes to my router then the internet.
and one nic that i will be using a cross over cable to another pc.

i would like to tell flashfxp if the ip address to connect to is then use this nic. if it anything else go the other way.

please could you help....
wagons41 is offline